Step by step guide to install your carpet professionally
Honestly, there is no rocket science in installing a
carpet on your own but it can be a little tricky and tiresome for a first
timers. With the right instructions and information you can easily do it on
your own. People are getting comparatively more obsessed with installing
carpets in their homes than before. Not only does carpets give a classy and
elegant look to your house but it also has health benefits. Follow these simple
steps in order to become a professional in installing carpets in your house.
Get
rid of the old carpet
It is obvious that you want to install a new carpet,
you have to first get rid of the old one. Clean the carpet and vacuum it for a
dust free work. Start to remove the carpet backwards from the door opening of
the room. Do not just remove it all of a sudden. Make proper roll and fold it
towards the end of the room. This way it will be easy to take outside. Carpet installation companies in Apache Junction AZ follows the same removal patterns.
Clean
the surface floor
Time for a proper cleaning. The surface beneath your
old carpet must be full of dust and dirt. Clean the floor and mop it with a
germ killing solution so that your new carpet might not get affected. Once the
floor is dust free you can proceed to the next step.
Put
the under pad
Don’t remove the old strips if not damaged. If the
strips are too old and you want to apply new ones you can. Fix the strips and
lay the under pad carefully and neatly. The look of your carpet will partly
depend on the placement of under pad. New under pads will ultimately enhance
the softness and beauty of your carpet.
Seam
it properly
If the room in which you are installing the carpets
needs more than one piece, you will have to work a little more. Professional
carpet companies in Apache Junction AZ cuts proper pieces according to the size
of your room. If you have those pieces it’s good for you. Seam those pieces
properly with seaming tape or glue.
Stretch
and Install the carpet
Leave your carpet to
stretch a bit before installing it. Once is done, just apply the carpet on the
floor. Make it look neat by excluding any creases. Use a knee kicker to fix
carpet on all the edges. You can use a trimmer or a utility knife to make sue
the carpet is fixed in every corner of the room.Add caption |
This is a really informative knowledge, Thanks for posting this informative Information. Mold Testing King of Prussia
ReplyDelete